User`s manual

1 DATECS EP-50
20 21
User’s Manual
4. OPERATION
4.1 Connecting AC Adapter
!
CAUTION
y Use only the specified AC adapter.
y When disconnecting/reconnecting the cable connector of the AC adapter,
be sure to hold the connector.
y Separate the AC adapter from other noise-generating devices.
y Pulling the AC power cord may damage it, resulting in a fire, electric shock,
or snapping.
y If a thunder/lightning storm is nearby, disconnect the AC adapter from the
socket and do not use the printer, because a fire or electric shock may occur.
y Do not put the AC power cord close to a heating device.
Its coating can mel and cause a fire or electric shock.
y Install the printer in a well-ventilated place, because the AC adapter
generates heat when it is used.
y Use the specified AC power source. Connect to a power source with sufficient
capacity. If the capacity is insufficient, a fire may result from heat generation.
y After using the printer or when not using it for a long period of time, be sure
to unplug the AC adapter from a plug socket for your safety.
4.2 Connecting Interface Cable
1 Turn off the power. (Mating side included)
2 Check the top and bottom of cable terminals, and connect to the interface
connector.
3 Connect the cable to the host computer.
4.3 Inserting the Paper
!
CAUTION
1 Hold the convexity on the rear of the printer cover, and raise it upward.
2 Cut the front end of the paper roll almost at a right angle.
3 Make sure that the power is turned on.
4 Pull the head-up level to this side to raise up the printing head.
5 If there is still some paper remaining after a paper-out indication, eliminate
the paper roll according to “4.8 How to Remove Remaining Paper Roll.”
6 Insert the front end of the paper roll straight into a paper insertion slot.
7 Set the paper roll firmly in the paper holder.
8 Put back the head-up lever. The paper roll is automatically puiied in by the platen
roller to feed a constant amount of paper. (When auto-loading is enabled.)
9 Put back the printer cover.
y Be sure to use the specified paper roll.
y Use of non-specified peper may not guarantee the print quality, printing
head life, and so on.
1 Turn off the power.
2 Connect the cable connector of the AC adapter
to the power connector located on the back
of the printer.
3 Connect the AC power cord of the AC adapter,
and plug it into a socket.