User`s manual

Setup
15
DATECS
Е
P
-
2000
Printer Configuration
EP-2000 uses nonvoltatile memory for storing some of the printer default configuration. The
following table shows the available options:
Memory Switch (see GS command) 1000000111000
BAUD RATE 115200 bps
PRINT DENSITY 100%
CHARACTER TABLE WESTERN (1252)
To change the settings:
1. Switch OFF the printer.
2. Switch ON the printer pressing FEED button.
POWER – green, ERROR – red, are rotated after every beep.
3. After the 4-th beep (after about 6 сек.) and 2 short beeps, accompanied
by 2 LED blinking – POWER – green, ERROR – red.
After releasing the FEED button in this printer state, the printer enters the hardware
setup mode (hardware menu) and prints the current settings.
4. Follow the printer instruction to make the necesary changes.
Long pressing the FEED button (YES) – confirms changes.
Short pressing the FEED button (No Changes) – cancels changes.
Care must be taken when changing factory preset
configuration information.
To exit the hardware menu switch off the printer.