User manual

USER MANUAL |

11!

CHARGING YOUR DPP-450

The DPP-450 uses a Lithium Ion rechargeable battery pack. Before first use,

the battery pack should be charged for at least (3) hours from full empty.

To prevent electrical damage to the DPP-450 and/or battery pack, please use

approved AC adaptors cables only.

1. Connect 24V charger cable to the DC charging jack as shown below.

Insert cable to DC jack to start charging.

2. When the device is turn on (holding turn on/off button), the LCD

display will show “CHG” text and a green led “CHARGE” is blink.

Figure 10

Warning:

• When charging the DPP-450, only use the approved/recommended 24

volt @ 5 amp dc adaptors. Failure to do so may cause charging

problems and potential damage to the DPP-450.

• When connecting the DC charging cable, take care as to not force the

plug into the connector as doing so may cause damage to the

connector.!