Manual

USB WIRELESS BRIDGE USER’S MANAUL REV. 02 6
configuration. The higher numbered COM port can be used to transmit or receive data over the USB
port.
LED Indication
The wireless bridge has four LEDS for indication. The Blue Power LED is lit any time the Wireless Bridge is
properly powered. A green TX LED and yellow RX LEDs indicate activity on the serial port of the device.
They do not necessarily reflect all activity that may be occurring over the air as they will only blink when
a properly addressed data packet is received. The Special function LED is lit when the USB port is in use.
Data Formats and Baud Rates
The default baud rate and data format is 9600 baud, 8 data bits, no parity and one stop bit. The baud
rate and data format can be adjusted by adjusting the BD and NB parameter of the radio module (See
the Changing the Baud Rate section). If the data of the sending or receiving devices do not correspond
with the data settings of the Wireless Bridge then the output data will appear garbled.