Manual
USB WIRELESS BRIDGE USER’S MANAUL REV. 02 3
Overview
The USB Wireless Bridge is designed to work with one of the other Datawave Wireless Bridge devices.
The USB Wireless Bridge enumerates as a multiple COM port device and emulates a standard COM port
for data. The USB wireless bridge is typically used with an RS-232, RS-485, ADIO Wireless Bridge or with
stand-alone Digi XBee modules. In a typical use case, the USB Wireless Bridge acts as a data collector for
one of these devices.
Due to the nature and driver requirements of USB, these devices cannot act as a wireless cable
replacement for a USB cable.
It is possible to mix and match wireless bridge products. The USB Wireless bridge will communicate with
an RS-485, RS-232, Analog and Digital I/O and other USB wireless bridge products that share the same
radio configuration.
Specifications
Performance
24LP 24HP 09SX
OVER
-
THE
-
AIR
DATA RATE
250 Kbps
250 Kbps
Low:
10Kbps
Mid: 110Kbps
High: 250Kbps
INDOOR/URBAN
RANGE
Up to 200ft.
Up to 300ft.
Up to 1000ft.
OUTDOOR/ RF LINE
-
OF-SITE RANGE
Up to 4000ft.
Up to 2 miles
Up to 10 miles
TRANSMIT POWER
6.3 mW
63 mW
1 Watt
RECEIVE SENSITIVITY
-
101 dBm
-
101 dBm
Low:
-
113
dBm
Mid: -106 dBm
High: -103 dBm
Table 1. General Performance Specifications