Manual
USB WIRELESS BRIDGE USER’S MANAUL REV. 02 12
Fig. 9 Terminal Session Command Example
Configuring the XBee Module
The USB Wireless Bridge utilizes the Digi XBee module. Consequently, all radio settings can be read or
set with Digi AT commands or Digi X-CTU software. As a general rule the only commands that might
need be set are the Networking commands. Any I/O commands or other features are not used. See
Digi’s website at www.digi.com and the XBee user manual and discussion forums for more information.
Antennas
The Wireless Bridge uses an RP-SMA Female connector. The Wireless Bridge is approved to be used with
any 2.1dBi RP-SMA Male antennas that are frequency compatible. Datawave antenna part numbers
include:
Part Number: ANT-2400-RP-2-A (2.4 GHz for the 24LP & 24HP variants)
Part Number: ANT-900-RP-2-A (900 MHz for the 09SX variant)