Schematic

RS-485 WIRELESS BRIDGE USER’S MANAUL REV. 02 8
Point-to-Multipoint
Fig. 5 Point-to-Multipoint Configuration
Figure 5 shows a typical point-to-multipoint configuration. By default, all the Wireless Bridge devices will
broadcast their data meaning that point-to-multipoint mode will work without any configuration. Used
this way, the Wireless Bridges are connected to devices that typically work in a poll/response protocol
such as MODBUS. If there is the potential for other Wireless Bridge networks to be in the same area,
then all devices in a given network may want to be set to a non-default PAN ID.