TFT LCD MONITOR USER'S MANUAL 4 TFT LCD MONITOR USER'S MANUAL Before Installing Your Monitor ABOUT Your MODAL Precaution Introduction Product Package Renee ees es Installing the Monitor levee Adjusting the Monitor eee ee ee Using OSD Sent nme vn se Signal Connector Pin outs Video Modes Specification rove te ee nee ee ae ge
TFT LCD MONITOR USER'S MANUAL Chapter 1. BEFORE USE | Be for hi 4 your Mon Bead this manual cover to cover. PAY ATTENTION to all WARNINGS and CAUTIONS. DO NOT use computer components that are not recommended by the manufacture, Do ont attempt to service the monitor by yourself. If a problem occurs, contact the authorized service center, [8 Ho This monitor is a microprocessor-controlled color monitor which uses a TPT LCD panel.
TFT LCD MONITOR USER'S MANUAL ie: ode Resolution H-Freq. (KHz) Y-Freq, (Hz) oA 640400 3s 0 640%480 31.5 60 6404480 a9 70 640480 37.8 72 640%480 37.5 ki SUGAR BOOMBOX 37. 0 BOOMBOX 43.7 kil BOOKED 48,1 12% 800600 46.8 75 Xs& 1024X768 48.3 80 1024x768 56.4 70 10244763 57.5 iE 1024X768 60 75 EXAM 1152K864 54.1 80 1152%864 63,9 70 1153%864 64,9 7a 11521864 67.5 75 SHEA 1280K1024 64 60 1280K1024 76.
TFT LCD MONITOR USER'S MANUAL A e Mon The monster is equipped with an auto-sensing power supply for voltage ranges from 60-50Hz. Confirm the line voltage designation on the rear panel of the monitor, FOLLOW THESE STEPS TO INSTALL THE MONITOR 1. Before you connect the cables, make sure that the monitor and the system unit power switches are OFF 2. Plug one end of the pippin signal cable to the monitor and the other emi to the video signal cornerstone at the rear of the system.
TFT LCD MONITOR USER'S MANUAL VIDEO INPUT First, you must activate the OSD mem: through pressing the MENU button, the mem will show as below: Brightness © Adjusting Brightness Contrast © Adjusting contrast H-Position © Adjusting horizontal position y-Position : Adjusting vertical position Din Control © Adjusting dim Saturation © Adjusting Saturation Hue © Adjusting Hue Language © Select Language ROA Mode © Select input signal Information © Display information 8 TFT LCD MONITOR USER'S MANUAL Chapter 3, ADJUS
TFT LCD MONITOR USER'S MANUAL re Menu RGB INPUT First, you mist activate the USD menu through pressing the MENU button, the menu will show as below: Brightness © Justifying Brightness Contrast © Adjusting contrast H-Position © Adjusting horizontal position y-Position : Justifying vertical position Clock © Justifying clock Clock Phase © Adjusting phase Color : Adjusting color Video Level © Select RIB-signal peak voltage Language © Select OSD language (English, Germany, French, Spanish. Italian) hut-Config.
Tested To Comply With FCC Standards FOR HOME OR OFFICE USE FCC Compliance Statement Thin equipment has been tested and found to comply with the limit for a lass B ital device pursuant to Part 15 of the FOC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is aerated in a residential installation This equipment generates, uses and can radiate raid frequency energy.
