Specifications

Single Channel Full Frame 4:2:2 Time Base

Corrector

•

TBC-100 is specially designed for video processing with a PC. Most video camcorders do not produce stable

synchronized signals. This can cause

poor video image quality when capturing video to your PC. The TBC-100 corrects this problem by replacing all sync

signals from the video source

with new signals. By using a digital full frame synchronizer, the TBC-100 insures that your video captures are clear and

clean.

• Frame synchronization with full frame memory

• Re-generates all synchronization signals to stabilize

the video

• Compatible with all formats (VHS, S-VHS, VHS-C, S-

VHS-C, Video 8 & Hi8)

• Auto-detects NTSC or PAL format

• Wide bandwidth- 4.5 MHz in Y/C and 3.5 MHz in

composite

• 8-bit video resolution – 4:2:2 sampling rate

• DP less than 1 degree – DG less than 2%

• Low noise – S/N ratio >50dB

PAGE 1
Single Channel Full Frame 4:2:2 Time Base Corrector • TBC-100 is specially designed for video processing with a PC. Most video camcorders do not produce stable synchronized signals. This can cause poor video image quality when capturing video to your PC. The TBC-100 corrects this problem by replacing all sync signals from the video source with new signals. By using a digital full frame synchronizer, the TBC-100 insures that your video captures are clear and clean.
PAGE 2
Typical Installation Installation with a Capture Card
PAGE 3
Connection 1. If you connect both S-video and composite video sources to the TBC-100, the card will automatically default to S-video. For composite video, you can not plug in an S-video input. 2. DC power input connector J601, use the enclosed “Pigtail” connector to connect the power source from PC power supply to the TBC-100. Pigtail Extension Connector (included) 3. TBC-100 apply both S-video and Composite video outputs for either S-video or Composite video input.
PAGE 4
Installation: 1. Turn off PC. 2. Disconnect power cord from PC. 3. Insert the TBC-100 into any PCI slot in your PC. 4. Use a “pigtail” connector to hook up the power connector from your PC power supply to TBC-100 dual power input socket J601 (Label on card diagram). If you do not have an extra power supply, see your dealer or a qualified technician for assistance. 5. Install the video equipment as shown in installation diagram. 6.