User guide

16
The following features can only be accessed by an
APPROVED Datatool
®
dealer. Should you wish to
have a setting changed from the factory default please
discuss this with your dealer fist. The factory default
settings have been chosen to deliver the optimum
performance from the system.
The factory default settings are in bold text.
NOTE: The inclusion of arm and disarm indication
beeps is strictly forbidden in all EU countries.
Special features (Dealer Selectable only)
No. Feature Settings available
1 Erase other transmitter codes (save
code of transmitter being used)
This switch removes all remotes except the one
being used to carry out the process. Any remotes
required to operate the system MUST be re-coded
after carrying out this function
2 Return software switches to default This setting returns ALL software switches to the
factory default, including customer set switches
3 System diagnostics with event memory Give last five trigger types in reverse order
4 Movement sensor adjustment 8 settings, range of 2 to 9 degrees nominally
Default setting is 7 degrees.
5 Shock sensor adjustment 10 settings
Default Setting Level is 8
6 Arm / Disarm Tones On/Off
7 Panic On/OFF
8 Nudge sensor Number of led flashes = Warn away setting
(Default setting at level 3)
1 Instant trigger – triggers system on first
impact detected
2 1 Warn-away bleep and trigger on second
impact within two minutes
3 2 Warn-away bleeps and trigger on third
impact within two minutes
4 3 Warn-away bleeps and trigger on four
impact within two minutes
5 4 Warn-away bleeps and trigger on fifth
impact within two minutes
6 Permanent Warn-away - bleeps the alarm on
impact but will not trigger system.
7 No Reaction – The nudge sensor is turned off