User`s manual

DT-6061 User's Manual - Platform (Build 16.0)
11/12/04 Datatek Applications Inc. 33
Interrupts stopped: 0 started: 0
init - k: 13 u: 0
none - k: 1 u: 1
onsite - k: 5 u: 4
none%0 - k: 3 u: 2
none%1 - k: 1 u: 1
none%2 - k: 2 u: 1
none%3 - k: 2 u: 0
.
.
.
tn3270 - k: 144 u: 59
tn3270%0 - k: 146 u: 63
cme - k: 0 u: 0
none%a - k: 4 u: 1
tn3270%1 - k: 115 u: 66
tn3270%2 - k: 119 u: 35
none%b - k: 3 u: 1
Notes:
• First line (0:) shows total kernel plus idle time*
• Second line (1:) shows total application time*
• Subsequent lines show kernel (k:) and application (u:) time* for each thread.
• Thread names contain an application type name or a system thread name. (There is no
relation between thread names and particular instance numbers.)
All times are in 100'ths of a second
7.3.3 DEV
Syntax: diag dev (use lower case)
The dev subcommand reports CPU utilization and interrupt counts by category, including device
drivers, system, applications, and scheduler (idle). The command prints utilization percentage
and interrupt counts since the last dev command.
Sample Output
diag dev
*** IV ***
con: 0 0% 89
sch: 629 0% 121120
sclk: 0 0% 113992
eth0: 132 0% 8912
SW+0: 127 0% 4682
SW+1: 0 0% 5700
SW+2: 0 0% 2280
sys: 4886 1%
app: 305 0%
sched: 407077 99%
Notes:
Each line represents a gross category of CPU usage. The numbers in each line are: