User`s manual

DT-6061 User's Manual - Platform (Build 16.0)
11/12/04 Datatek Applications Inc. 16
4 CABLING
4.1 SERIAL CONSOLE SETUP
The DT-6061 is managed through its serial console port by a terminal, PC, dial-up modem, or
BNS asynchronous connection.
Specific instructions for configuration of SAM, TY12 and MSM asynchronous ports are available
in the appropriate BNS module, reference guide. DT-6061 specific, configuration notes are
described herein.
Console cables are available from your DT-6061 Reseller and may be required for console
connection through BNS, TY12 and MSM modules, SAM64/504 Multiplexors and connection
through an Ortronics distribution patch panel (see figure and table below).
SAM 16
Model
straped for
constant DTR
258 adapter
or mod tap
patch panel
Ortronics
patch panel
PC or Dumb
Terminal
AH
Male
AH
Male
AH
Male
AH
Male
To Node
To remote modem
B25 Cable
to ty12, msm
sam64/504
To ty12, msm
sam64/504
modular cable
modular cable
modular cable (SPECIAL WIRING)
DT- 6061
RJ45
modular cable
modular cable (SPECIAL WIRING)
Important! A modular cable with “SPECIAL WIRING” is different from a generic, 8 wire modular
cable. The DT-6061 console will typically connect to a PC/dumb terminal or a BNS asynchronous
device such as a TY12 or SAM. The diagram in Chapter 11 describes how to construct the with
“SPECIAL WIRING” . Otherwise, the cable can be ordered. Use the table below for part number
information.
The following cables and adapters are available for console connections:
Cable or Adapter
Order Information
(Lucent
Technologies)
Order Information
(CBM of America)
8 pin modular to 8 pin modular cable (standard)
Comcode 408981653
(25’)
P-10419-XX
(XX ‘ length)
8 pin modular to 8 pin modular cable (special wiring)
(25’) - The wiring schematic is shown in Appendix B.
Comcode 408198133 DTCONCAB-25
Male 25
p
in to 8
p
in connector
(
AH Male
)
ED5P055-31 G
(
139
)
A
DPG139
258 Ada
p
ter ED5P055-31 G
(
155
)
A
DPG155