User`s manual

DT-6X60 User's Manual - Platform (Build 2.0)
router is supposed to send back an ICMP Time Exceeded message to the source system. Tracert
determines the route by sending the first echo packet with a TTL of 1 and incrementing the TTL by
1 on each subsequent transmission until the target responds or the maximum TTL is reached.. The
route is determined by examining the ICMP Time Exceeded messages sent back by intermediate
routers.
The IP address can use a domain-style address, providing the dns and/or hosts configuration has
been properly entered.
6.8.8 VERIFY CONFIGURATION SETTINGS - VFY
The vfy command is used to report configuration settings for the following categories using the
indicated syntax:
• vfy app - application installation and run-time status
• vfy banner
• vfy cfg … - application instance selection
• vfy console – cug list for the console
• vfy cug - closed user group definitions
• vfy dns - domain name server configuration
• vfy dtproduct
• vfy hosts - host-IP translation table
• vfy mod - module configuration and status
• vfy snmp - snmp settings
• vfy stby – for duplex configurations only (see sections 6.9.3 and 6.9.4.)
The verify reports for banner, cug, dtproduct, dns, hosts, and snmp are simple representations
of the configuration parameters described in each corresponding command. The more complex
verify reports are explained in this section.
6.8.8.1 V
ERIFY R UNNING A PPLICATIONS – VFY APP OR VFYAPP
Syntax: vfy app
vfyapp
The vfy app (or vfyapp) command shows the list of installed applications, along with their build
(revision) numbers and build dates. Unregistered applications are displayed with the notation "not
registered." The display continues with a list of applications currently running in each application
slot (instance), including "none", along with an internal identifier. Instances that are removed from
services will show an "oos" status. Instances configured for an unregistered application will show
an "unreg" status. For some applications, there may occasionally appear a short temporary status
report generated by some instances of the application.
6.8.8.2 V
ERIFY C ONFIGURED A PPLICATION I NSTANCES – VFY CFG OR VFYCFG
Syntax: vfy cfg [<instance> [cnt=<num>]]
vfycfg [<instance> [cnt=<num>]]
06/07/07 Datatek Applications Inc. 39
The vfy cfg (or vfycfg) command displays each configured instance, and what application type is
configured on that application instance.