User`s manual

DT-6X60 User's Manual - Platform (Build 2.0)
The cpu subcommand reports CPU utilization by process. Processes may be associated with
instance numbers as reported by the vfyapp command.
Sample Output
diag cpu
0: 398711 99%
1: 5014 1%
Interrupts stopped: 0 started: 0
init - k: 13 u: 0
none - k: 1 u: 1
onsite - k: 5 u: 4
none%0 - k: 3 u: 2
none%1 - k: 1 u: 1
none%2 - k: 2 u: 1
none%3 - k: 2 u: 0
.
.
.
tn3270 - k: 144 u: 59
tn3270%0 - k: 146 u: 63
cme - k: 0 u: 0
none%a - k: 4 u: 1
tn3270%1 - k: 115 u: 66
tn3270%2 - k: 119 u: 35
none%b - k: 3 u: 1
Notes:
• First line (0:) shows total kernel plus idle time*
• Second line (1:) shows total application time*
• Subsequent lines show kernel (k:) and application (u:) time* for each thread.
• Thread names contain an application type name or a system thread name. (There is no
relation between thread names and particular instance numbers.)
All times are in 100'ths of a second.
6.8.3.3 D
EVICE – DIAG DEV
Syntax: diag dev (use lower case)
The dev subcommand reports CPU utilization and interrupt counts by category, including device
drivers, system, applications, and scheduler (idle). The command prints utilization percentage and
interrupt counts since the last dev command.
Sample Output
diag dev
*** IV ***
con: 0 0% 89
06/07/07 Datatek Applications Inc. 36
sch: 629 0% 121120