User`s manual

DT-6X60 User's Manual - Platform (Build 2.0)
Important! A modular cable with “SPECIAL WIRING” can be ordered using the table above or
built using the wiring diagrams provided in this manual in section
7. The pin-outs for the 9-pin
connector is shown in section 7.1
.
4.1.2 CONSOLE CONFIGURATION NOTES FOR BNS-2000/BNS-2000 VCS NETWORKS
 Configure SAM, TY12 and MSM console connections as 9600 bps with 8 bits and no
parity, and use a DCE type cable.
 Configure SAM and MSM console connections as type “host” and as a “pap” (permanently
active port).
 Configure TY12 console connections as type “console”.
4.2 D ATA C ONNECTIONS - LAN P ORT
The DT-6X60 is connected to the LAN through its 10/100 Base-T auto sense port. Connect a
standard Category 5 twisted-pair data cable terminated with an RJ45 connector to the DT-6X60 at
the port labeled LAN. Connect the other end to a 10/100 Base-T hub, etherswitch, or router on a
local LAN segment that provides access to a wide-area IP-based network. Category 5 cables can
be obtained through CBM of America or your local supplier.
Cable
Order Information
CBM of America
Category 5 10 Base-T P-10596-XXX*
Category 5 100 Base-T P-11754-XXX*
*XXX is cable length desired
06/07/07 Datatek Applications Inc. 16
Table 4: Category 5 Cable Ordering Information