User`s manual

DT-6X60 User's Manual - Platform (Build 2.0)
The serial console port interface, which is labeled as CON on the DT-6XXX, requires a standard
RJ45 terminated, twisted pair, data cable. It connects as data terminating equipment (DTE) to an
asynchronous device and uses RS-232C signaling. Connection to the DT-6X60 console is required
for initial configuration of the IP parameters for the DT-6X60 platform. Otherwise, the console can
be disconnected during normal operation and only the various logical telnet consoles used to
administer the platform or various instances of the applications. See section 4.1 for details on
cabling the serial console. The serial console is configured as 9600 bps, 8 bits, and no parity.
2.4 10/100 B ASE -T LAN
The LAN connection is a 10/100 Base-T interface on the front of the unit that is labeled “10/100-
Base-T”. The interface requires a standard RJ45 terminated Category 5 twisted-pair data cable. It
connects to a 10/100 Hub, Etherswitch, or router on a local LAN segment providing access to a
wide-area IP based network. This port supports TCP/IP peer-level protocols (e.g. TELNET, TCP,
IP, ARP, SNMP, etc.). The LAN interface will automatically negotiate the speed with the network
interface PHY.
2.5 LED S
The faceplate contains light emitting diodes (LEDs) used to report DT-6X60 activity and status:
LED Function LED Color LED Description
PWR Green Unit Power Indicator
ALARM Red Reset Indicator & General Failure Indicator
LNK/ACT Green Link & Activity (Blink) Indicator
DPX/COL Red Duplex & Collision (Blink) Indicator
06/07/07 Datatek Applications Inc. 11
Table 2: Faceplate LEDS