User`s manual

DT-6061 User's Manual - Platform (Build 17.1)
12/14/09 Datatek Applications Inc. 42
The vfy cfg (or vfycfg) command displays each configured instance, and what application type is
configured on that application instance.
The <instance> parameter is an optional argument to specify the beginning instance number to
begin the display. If not specified, it defaults to the number one. The report displays the instance
number and application installed on that number. If the cnt=<num> parameter has also been
specified, that number of configured instances will be displayed starting from the given instance
number. (Previous versions of the DT-6061 used num= for this purpose. The older syntax is still
supported.) With no parameters, all configured instances are displayed.
6.8.8.3 V
ERIFY M ODULE – VFY MOD OR VFYMOD
Syntax: vfy mod
vfymod
The vfy mod (or vfymod) command shows the DT-6061 module parameters and properties:
Registration status, system label, IP address, subnet mask, gateway IP address, the physical
Ethernet configuration, the redundancy status and configuration, if any, host name,
MAC address,
serial number, the manufactured "right to use" value, the platform software revision number and
date, and the elapsed time since the system was booted. If platform installation is incomplete, an
additional line of information shows the next action required. If the platform software is not
registered, an additional line says so. If pending system reconfiguration requires a reboot, an
additional line says so.