User`s manual

DT-6061 User's Manual - Platform (Build 17.1)
12/14/09 Datatek Applications Inc. 35
non-volatile memory. There is only one trap=<community>. The dest=<IP address> parameter
configures the IP address of the target trap manager. The snmp vfy command (same as vfy
snmp) displays the current settings of SNMP configuration.
The snmp command prompts for all parameters not specified on the command line. Simply type
snmp in order to add or change any parameters. If the present value that is printed is to be
retained, hit newline in response to the prompt. In order to add to an existing list for the set and
get communities, type in the old values as well as the additions for that parameter when
prompted. To delete all values for a keyword, type the word “none” as the value. Special
characters and escape sequences are accepted for community strings, sysName, sysLoc, and
sysContact parameters, but must be entered at the prompt for that parameter, not on the
command line.
When the SNMP configuration is changed, the agent is restarted. Whenever the DT-6XXX
reboots or the agent is restarted, a warm-start trap is sent to the configured trap manager. The
only other trap sent by the DT-6XXX platform agent is "authentication fail" when a manager
attempts to use a community name not on the list. This trap is only sent if a manager has enabled
it to be sent.
The snmp sysName, sysLoc, and sysContact are changeable via an SNMP manager as well as
via the console.
The enterprise object ID of the DT-6061 platform is 1.3.6.1.4.1.3791.3.7
,
for the DT-6160 it is 1.3.6.1.4.1.3791.3.13
,
and for the DT-6260 it is 1.3.6.1.4.1.3791.3.14
.