User`s manual

DT-6061 User's Manual - Platform (Build 17.1)
12/14/09 Datatek Applications Inc. 16
4 CABLING
4.1 S ERIAL C ONSOLE C ONNECTION AND C ONFIGURATION
4.1.1 CABLING THE DT-6061 SERIAL CONSOLE
This section describes the options for cabling a DT-6XXX serial console port, to allow the DT-
6XXX platform to be managed by a terminal, PC, dial-up modem, or asynchronous network
connection. The following diagram shows the connection options:
DT-4000
Modem
strapped for
constant DTR
258 adapter
or mod tap
patch panel
Ortronics
patch panel
PC or Dumb
Terminal
RJ45
Male
AH
Male
AH
Male
AH
Male
To Node
To remote modem
B25 Cable
to ty12, msm
sam64/504
To ty12, msm
sam64/504
modular cable
modular cable (SPECIAL WIRING)
DT- 6XXX
RJ45
modular cable
modular cable (SPECIAL WIRING)
PC or Dumb
Terminal
9pin
Console
Adapter
modular cable
modular cable (SPECIAL WIRING)
Figure 5: Console Cabling Options
The following cables and adapters are available for console connections:
Table 3: Console Cable Order Codes
Cable or Adapter
Order Information
(Lucent
Technologies)
Order Information
(CBM of America)
8 pin modular to 8 pin modular cable (standard)
Comcode 408981653
(25’)
P-10419-XX
(XX ‘ length)
8 pin modular to 8 pin modular cable (special wiring)
(25’) - The wiring schematic is shown in Appendix B.
Comcode 408198133 DTCONCAB-25
Male 25 pin to 8 pin connector (AH Male) ED5P055-31 G (139) ADPG139
258 Adapter ED5P055-31 G (155) ADPG155