User`s manual

DT-6061 User's Manual - Platform (Build 17.1)
12/14/09 Datatek Applications Inc. 15
5) Attach console cable by plugging 1 end of the RJ45 terminated, twisted pair, data cable into
the DT-6061 console interface and the other into the port of the asynchronous device that will
be used to configure or manage the DT-6061 (see Cabling section).
6) Run your 48V DC (return, minus and ground) wires from a central source through the strain
relief clamp (for DC wire stabilization). On the DT-6061 faceplate, attach the return, minus
and ground wires to the return, minus and ground connections respectively of the terminal
block labeled 48V DC.
3.1.2.4 R
ACK -M OUNT DT-6061 (48V DC P OWER I NPUT )
1) Attach the mounting brackets (19" or 23") to each side of the DT-6061.
Note: Brackets have a left or right designation. With the DT-6061 facing forward the left
bracket is attached to the left side of the DT-6061. Left-sided brackets are distinguished by
the two pre-tapped screw holes residing on the forward facing portion of the bracket.
2) Fasten the strain relief to the DT-6061 rack mount bracket.
3) Fasten the DT-6061 to the equipment rack using appropriate screws (typically supplied by the
equipment rack manufacturer).
4) Attach data transport cable(s) (see Cabling section).
5) Attach console cable by plugging 1 end of the RJ45 terminated, twisted pair, data cable into
the DT-6061 console interface and the other into the port of the asynchronous device that will
be used to configure or manage the DT-6061 (see Cabling section).
6) Run your 48V DC (return, minus and ground) wires from a central source through the strain
relief clamp (for DC wire stabilization). On the DT-6061 faceplate, attach the return, minus
and ground wires to the return, minus and ground connections respectively of the terminal
block labeled 48V DC.