Instructions

UM-0085-B09 DT80 Range User Manual Page 282

Inside the DT80

Accessing the main battery (if fitted)

1. Remove the power connector

2. Remove the screws from the other end of the logger

3. Remove this end of the logger

4. Pull the purple 'battery tail'

5. Disconnect the battery terminals

Figure 115: How to remove the main battery

Warning1: When reconnecting the main battery, observe the correct polarity. The red plug connects to the positive (+) battery terminal.

Warning2: Any replacement battery must be identical in specification to the factory fitted battery. There is a risk of explosion if the

battery is replaced by an incorrect type.

Warning3: Dispose of used batteries via an appropriate recycling facility only.

Warning4: When reinserting the main battery, ensure that the battery is oriented so that battery terminals are closest to the upper side

of the battery. If the battery is inserted upside down then the terminals may contact the case, causing a risk of a short circuit.