Instructions

UM-0085-B09 DT80 Range User Manual Page 214
RG
If you choose to use the no-ip.com service instead, then the required settings are:
PROFILE MODEM_SESSION DDNS_SERVER_URI=dynupdate.no-ip.com/nic/update
PROFILE MODEM_SESSION DDNS_SERVER_PORT=80
If you wish to use some other provider then you will need to optain the appropriate address update URI and port number
from the provider.
Third, the details of your DDNS account need to be entered – that is, your username and password:
PROFILE MODEM_SESSION DDNS_ACCOUNT=username
PROFILE MODEM_SESSION DDNS_PASSWORD=password
The DT80 will use these to log in to your DDNS account each time it needs to update its IP address.
Finally, the logger's domain name, that you have already associated with the DDNS account, needs to be entered:
PROFILE MODEM_SESSION DDNS_HOST_NAME=domain-name
For example, a typical set of DDNS settings would be as follows:
PROFILE MODEM_SESSION
[MODEM_SESSION]
...
*DDNS_ENABLE = YES
DDNS_SERVER_URI = members.dyndns.org/nic/update
DDNS_SERVER_PORT = 80
*DDNS_ACCOUNT = megatech
*DDNS_PASSWORD = JackFlash
*DDNS_HOST_NAME = turbine12.dyndns.org
*DDNS_REGISTERED_IP = 123.209.58.192
Note: the DDNS_REGISTERED_IP setting does not need to be set; it will be updated automatically following a successful DDNS
update.
 dEX Settings
In the dEX Configuration Builder, all DDNS settings are entered on the Modem DDNS page, as shown in Figure 81.
Figure 85: DDNS configuration page