User manual

Datasheen D902AC User Manual
Page 5 Total 25 Pages
Introduction：
1、 Use a telephone cord to connect the LINE port of the splitter with the RJ-11 port (the phone jack) on
the wall.
2、 Use another telephone cord to connect the ADSL port of the splitter with the LINE port of the ADSL
Modem.
3、 Use another telephone cord to connect the telephone set with the PHONE port of the splitter.
4、 Connect Ethernet port of the ADSL MODEM with 10/100BASE-T port of the computer using the
network cable that comes with the modem.
5、 Plug in the power cord, and turn on the power.
If you do not want Internet services and telephone voice services simultaneously, please just connect the
LINE port of the ADSL Modem with the RJ-11 port (the phone jack) on the wall using a telephone cord. In this
case, the splitter is not necessary.
2.3 LED STATUS INDICATION
Table 2.3
Steady light Flashing Fast flashing Off
POWER (red) Power on / / Power off
LINK(yellow) The modem is in
good connection
In handshaking status / Connection not set up
DATA (green) Wan is connected / Transmitting or
receiving data
Wan is not connected
PC
Green Ethernet line is
connected
/ Ethernet is
Transforming data
Ethernet line not connected
properly
Red USB is connected USB is Transforming
data
USB is not connected
properly
Orange USB and Ethernet
are connected
USB and Ethernet are
Transforming data
USB and Ethernet are not
connected properly