Setup guide

Dirac Theater Setup Guide Version 1.01
Document # 9301H40300V1.01
14
When the measurement is completed, the measurement counter is updated, as shown in Figure 13.
Figure 13. Make Recordings Screen
4. Move the microphone to a different location and take a new reading.
5. Save the measurements when all measurements are complete.
2.4. Optimize the System
The next step is to use Dirac Live
®
to optimize the system, by performing both frequency corrections and
impulse corrections (or time alignments). It is recommended that you save the measurements before
starting the optimization. Saving the measurements allows you to make corrections to the target curve and
repeat the optimization without repeating the measurement portion.
In Figure 14 below, you can see what the frequency measurements for a particular channel (1) look like.
The blue plot is the average magnitude response for this channel. A suggested target curve is plotted in
red to show what this channel would look like after optimization.
The Dirac Live
®
application allows you to alter the target. For example, if you want to put a bass bump
into it, or you want to affect the high end a bit, you can adjust the red target line.
When the measurement is completed, the
measurement counter is updated.