User manual

<IP>

This option sets up the Network Interface on the dCine:

<IP>

</IP>

This configuration can be modified via the GUI:

Buttons: Admin->System

The top right portion of the screen will show the IP configuration. Clicking on the Change button

allows the user to edit the values.

It is important that the dCine be connected to the internet with the correct network configuration so

that remote users can access the system. Remote support engineers can then access the dCine via

the Web for monitoring, network ingest and Network based automation purposes.

The correct network configuration is also required for the VPN to connect to the digitAll support

network. The network requires that the dCine have access to the internet in order for the VPN to

work. For this reason, it is important that the IP address, gateway and DNS be set up correctly.

Typically many installers leave the configuration on DHCP. The DHCP configuration enables the

dCine to select the correct setting from the Internet DSL modem or similar device.

However, it is possible that the IP address can change between reboots when using DHCP. STATIC

configuration is best (setting by hand) if you are likely to be effected by IP address changes.

A dCine can have more then one network interface installed. In order to nominate which interface

the dCine GUI controls, the desired network interface must be allocated a specific name.

“digitAll – MediaPlayer”

When the BootStrap.exe runs and discovers a new install, it will run a script to ensure an

interface exists with this name. It will look for the most likely interface and rename it.

If <EnableDHCP> is YES, the <Address>, <Netmask> and <Gateway> options are ignored.

If <DNSAutoEnabled> is YES, <DNSAddress> is ignored.

<Address>, <Netmask>, <Gateway> and <DNSAddress> are as named.