Datasheet
DTM63393C
1GB, 240-Pin Unbuffered ECC DDR2 DIMM
Document 06008, Revision A, 01-Oct-10, Dataram Corporation © 2010 Page 5
Differential Input Logic Levels (T
A
= 0 to 70 C, Voltage referenced to V
ss
= 0 V)
PARAMETER S
y
mbol Minimum Maximum Unit Note
DC Input Signal Voltage
V
IN(DC)
-0.300 V
DD
+ 0.300 V 1
DC Differential Input Voltage
V
ID(DC)
-0.250 V
DD
+ 0.600 V 2
AC Differential Input Voltage
V
ID(AC)
-0.500 V
DD
+ 0.600 V 3
AC Differential Cross-Point Voltage
V
IX(AC)
0.50 V
DD - 0.175
0.50 V
DD + 0.175 V 4
Notes:
1. V
IN(DC)
specifies the allowable DC excursion of each input of a differential pair.
2. V
ID(DC)
specifies the input differential voltage, i.e. the absolute value of the difference between the two voltages of a differential pair.
3. V
ID(AC)
specifies the input differential voltage required for switching.
4. The typical value of V
IX(AC)
is expected to be 0.5 V
DD
and is expected to track variations in V
DD
.
Capacitance (T
A
= 25 C, f = 100 MHz)
PARAMETER Pin Symbol Minimum Maximum Unit
Input Capacitance, Clock
CK[2:0], /CK[2:0] CIN1 3 6 pF
Input Capacitance, Address
and Control
BA[2:0], A[13:0], /S0, /RAS, /CAS, /WE,
CKE0, ODT0
CIN2 9 36 pF
Input/Output Capacitance
DQ[63:0], CB[7:0], DQS[8:0], /DQS[8:0],
DM[8:0]
CIO 3 4 pF
DC Characteristics
(T
A
= 0 to 70 C, Voltage referenced to V
ss
= 0 V)
PARAMETER Symbol Minimum Maximum Unit Note
Input Leakage Current Command and Address
I
LI
-80 80 μA 1
Input Leakage Current S0,CKE0, ODT0
I
LI
-40 40 μA 1
Input Leakage Current CK[2:0], /CK[2:0]
I
LI
-30 30 μA 1
Input Leakage Current DM
I
LI
-10 10 μA 1
Output Leakage Current DQS, DQ
I
OZ
-10 10 μA 2
Output Minimum Source DC Current
I
OH
-13.4 - mA 3
Output Minimum Sink DC Current
I
OL
+13.4 - mA 4
Notes:
1. These values are guaranteed by design and are tested on a sample basis only
2. DQx and ODT are disabled and 0 V ≤ V
OUT
≤ V
DD
.
3. V
DD
= 1.7 V, V
OUT
= 1420 mV. (V
OUT
- V
DD
)/I
OH
must be less than 21 Ohms for values of V
OUT
between V
DD
and (V
DD
- 280 mV).
4. V
DD
= 1.7 V, V
OUT
= 280 mV. V
OUT
/I
OL
must be less than 21 Ohms for values of V
OUT
between 0 V and 280 mV.