User manual

AP 230 USER MANUAL 44
Check the linearity of the labels
and if necessary close the holes
with adhesive ribbon and try
again.
The label does not cover the
external hole drilled on the plate.
The label does not cover all the holes
drilled on the plate.
The system after the printout
of the label signs error.
(led lights END PAPER/
RIBBON)
The system after the printout
of the label signs error also if
the label covers all the hole
drilled on the plate.
(led lights "END PAPER/
RIBBON").
The vacuum is not created inside
the plate.
Check that the visible part of
the plate rubber tube is flat,
cracked or that the joints are
low.
The "VACUUM SWITCH" does
not switch, the system does not
detect the presence of the label
and signs error.
Check that the vacuum filter is
clean, otherwise replace it.
Contact Techinical Assistance.
SYMPTOM POSSIBLE CAUSE ACTION
Check that the plate is ready for
the label format to be used,
otherwise close the holes with
adhesive ribbon and try again.
WARNING: When trouble shooting is over, and after replacing the
trounble, follow carefully the "SAFETY MODE FOR
THE MAINTENANCE" procedure as indicated on
paragraph 8.1 at point 6 e 7, for re-start the system.