User manual

AP 230 USER MANUAL 42
12.9 - SINGLE APPLICATION CYCLE
It is possible to execute by AP 230 system one single applying cycle, that is a down-
upward movement of the piston in accordance with the programmed time with
command "N", without any label ejection.
The command to be sent by serial line is the following:
/!
The complete description of the printer commands is indicated on "ST 230 USER
MANUAL" in the section "PROGRAMMING GUIDE".
13 - FINAL OPERATIONS
WARNING: Before proceeding with final operations, follow carefully
the "SAFETY MODE FOR THE MAINTENANCE" procedure
as indicated on paragraph 8.1 at point 5 - 6 - 7.
Insert the cable of the applicator into its 4 pin
connector located on the front panel of the
printer, as indicated on picture 30 on your left.
PICTURE 30 - FINAL OPERATIONS, APPLICATOR
CABLE.