User manual

AP 230 USER MANUAL 36
12 - SYSTEM CONFIGURATION; FRONT PANEL OPERATIONS AND
SOFTWARE COMMANDS
This section describes the special commands used to set up the AP230 system.
There are two different procedures:
- Front panel operations.
- Applicator software commands
12.1 - FRONT PANEL OPERATIONS SPECIFIC FOR THE APPLICATOR
SYSTEM
Here below the procedure to set up on printer ST 230 the specific commands of the
applicator:
- Enable the applicator
- Enable the object sensing photocell and printer operation mode
- Label calibration and offset adjustment
To proceed with the configuration phases, place the printer in SET - UP mode as
follows:
- Press key ON - LINE to reach the printer in OFF - LINE status.
Then press sequently the keys HEAD LIFT and ON LINE
All the leds are off (with exception of the red one) and the device is in configuration
mode.