User manual

AP 230 USER MANUAL 33
Push the applicator unit towards the printer to
adjust it lenghtwise, as shown on picture 26 on
your left.
To proceed with these adjustments (side and
lenghtwise) the holes drilled on the applicator
base has to be greater than the fastening
screw diameter in order to allow such
regulations.
WARNING: Generally there is no given distance to be kept between
applicator and printer, it is advisable to place them as near
as possible allowing an easy cartridge remove.
Keep with one hand the application assembly
and with the other one tighten the fastening
screws completely, in order to avoid any moving
of the assembly, as indicated on picture 27 on
your left.
Press the "FEED" button again to verify that during the fastening operations the
application assembly has not moved.
PICTURE 26 - LENGHTWISE CENTERING OF
THE PLATE.
PICTURE 27 - FASTENING SCREWS.