User manual

AP 230 USER MANUAL 32

WARNING: Before going on with checking the right application assem-

bly position, follow carefully the "SAFETY MODE FOR THE

MAINTENANCE" procedure indicated on point 1-2-3-4- of

paragraph 8.1.

Wait for the printer after the re-start operations (see point 4 paragraph 8.1) to print

the test label and that the led on key ON - LINE lights.

Put the printer in OFF - LINE following the here below instructions:

Press button ON - LINE to bring the device in OFF - LINE mode (led off).

Verify that the label is centered on the

application plate, that means that the two side

boards of the plate are equidistant from the

external sides of the label. Picture 25 on your

left, shows on point "B" the correct side

centering of the plate.

In case the label will not be centered (point "A"

of the picture), remove the label from the plate

and move sidewise the applicator assembly.

Press on the front panel of the printer the key "FEED" to have the re-print of the last

label. This allows to check the right alignment.

These operations should be repeated untill the label is

correctly centered on the application plate.

Holding the application assembly with the hands, in order to

avoid any movements that impair the side centering, proceed with lenghtwise

positioning as here below described:

PICTURE 25 - LABEL CENTERING ON THE

PLATE.