User manual

AP 230 USER MANUAL 31
11.1 - POSITION ADJUSTMENT OF THE PNEUMATIC APPLYING
ASSEMBLY.
WARNING: This adjustment has to be made before connecting the
system to electrical and pneumatic sources.
This adjustment is essential to the proper working of the system, and therefore has
to be executed with extreme care.
Adjust the application assembly so that the
internal side of the base will be aligned and
parallel to the side corresponding of the backing
plate.
Picture 24 on your left shows on point "A" a
wrong alignment and on point "B" a correct
alignment.
Finally tighten the fastening screws to avoid
any moving.
11.2 - CHECK THE CORRECT POSITIONING OF THE PNEUMATIC
APPLICATION SYSTEM.
Connect the system to the pneumatic and electrical sources following the instruction
on paragraph 6.1 and 7 of the present manual.
Open the compressed following instruction on paragraph 7, the plate is now ready
to receive the labels.
Switch-on the printer following the instructions on paragraph 6.2.
B
A
PICTURE 24 - PNEUMATIC APPLYING
ASSEMBLY ADJUSTMENT.