User manual

AP 230 USER MANUAL 30

10 - ADJUSTING THE FLANGES ON THE ROLL HOLDER

The roll holder inside flange has to be adjusted so that the paper is alligned with the

first paper guide located on the printer. For

that reason after loading the labels as discribed

on paragraph 9, keep with one hand the label

roll and with the other one bring the internal

flange near.

Picture 23 on your left shows on point "B" the

correct position of the flange and the properly

paper alignment.

Insert then the second flange near the label

roll.

11 - PNEUMATIC UNIT ADJUSTMENT

To correctly adjust the pneumatic group is essential to the proper working of the AP

230, as a wrong adjustment could create problems during working cycle of the

applicator.

Instructions have been divided into two different phases, as follows:

A - Mechanical adjustments to be carried out before connecting the

system to pneumatic and electrical supplying source (see paragraph 11.1):

- Adjustment of the applicator assembly position

B - Adjustments and checks to be carried out with the system joint to

pneumatic and electrical supplying source (see paragraph 11.2):

- Check of the correct pneumatic applicator position

- Adjustment of the air jet strenght and direction.

PICTURE 23 - FLANGES CENTERING