User manual

AP 230 USER MANUAL 28
1
2
3
PICTURE 20 - LABELS ROLL LOADING
MAGNETIC BRAKELOWER PAPER GUIDE
LABEL GAP
PHOTOSENSOR
PRESSURE ROLLER DEVICE
REWINDERS
ROLL
HOLDER UNIT
RIBBON
CARTRIDGE
9 - LABELS AND FOIL LOADING PROCEDURE
WARNING: Before proceeding with labels and ink ribbon loading, fol-
low carefully the "SAFETY MODE FOR THE MAINTENANCE"
procedure described on paragraph 8.1 at point 1 and 2.
To load the labels roll properly, proceed as follows:
1 - Insert a labels roll in the external roll
holder.
2 - Insert the external flange on the roll holder.
3 - Insert the paper into the slot locating on
the rear panel of the printer, as indicated
on picture 20 on your left.
The here below picture 21, shows the way that
labels have to follow inside the printer.
Load the labels by lifting up the printhead
turning the knob, being sure that the paper
guides have been adjusted to the width of the
labels and that the paper will pass through the
label gap photosensor located on the lower
paper guide. After fastening the silicon paper to the rewinder, check that the
pressure roller device is in the close position and lower the printhead.
PICTURE 21 - LABELS WAY
PRINTHEAD LIFTUP
KNOB
PAPER GUIDE ROLL