User manual

AP 230 USER MANUAL 20

6 - ELECTRICAL AND PNEUMATIC CONNECTIONS

6.1 - ELECTRICAL CONNECTION

AP 230 system has to be connected to the power supply , through the emergency

stopping device that has to be

fixed outside the interdiction

zone following the instructions

below:

1 - Prepare a feeding cable

with an adequate section not

less than 3 x 1,5 mm, where

from applicator side will be

mounted the dedicated female

connector that will be inserted

into the plug on the rear panel of

the printer.

2 - On the opposite pole of

the cable, mount the dedicated

spindle and insert it into the sup-

ply plug with protected contacts that is mounted on the emergency stopping device.

3 - Insert the female connector of the supply cable into the proper plug mounted

on the emergency stopping device.

4 - Connect the spindle of the power cord to an appropriate socket outlets with

following voltages:

220 VAC ± 10% 50/60 Hz

110 VAC ± 10% 50/60 Hz (as per require)

240 VAC ± 10% 50/60 Hz (as per require)

WARNING: Be sure that the power cord is connected to an electrial

installation with proper earthed.

Such electrical installation as per CEE safety rules.

PICTURE 15 - POWER SUPPLY