User manual

AP 230 USER MANUAL 19
5.4 - LOCATING OF THE FASTENING POINTS OF THE SYSTEM
The backing plate is equipped with a certain number of holes to be used to fasten
the system to the application line or to mount,
if desired, a backing flange for a support
column, as indicated on picture 14 on your left.
On the backing plate has been pre-drilled a
serie of eight holes : 4 M 10 and 4 M 8.
WARNING: In case of the above mentioned instructions are not carrefully
followed you can incurr residual mechanical hazards
due to a unlocking of the screws causing a loss of stability
of the system and its collapse.
On appendix "A" a dimentioned drawing of the backing plate is reported.
PICTURE 14 - AP 230 ON COLUMN