User manual

AP 230 USER MANUAL 18
5.3 - MOUNTING THE PNEUMATIC APPLICATION UNIT
Unpack the application unit and take from the tool kit the two screws M 8 x 30 mm
complete with their washers. Place the
application unit in its upright position, on the
front of the printer, hold it by one hand while
with the other one insert the two screws in the
two pre-drilled holes created on the base of
the application unit so that they will match the
holes on the backing plate, and fasten, without
locking, as indicated on picture 12 on your left.
NOTE: To adjust and center the applicator
both on side and lenghtwise re-
spective to the printer see the pa-
ragraph 11 concerning the pneu-
matic assembly adjustment.
WARNING: During this phase do
not connect the cable
of the applicator to the
plug (4 pin, male), loca-
ted on the printer front
panel, as indicated on
picture 13 on your left.
PICTURE 12 - MOUNTING THE PNEUMATIC
APPLICATION UNIT.
NO
PICTURE 13 - APPLICATION CABLE