User manual

AP 230 USER MANUAL 16
PICTURE 8 - FASTENING SCREWS.
Take off from the tool kit the two M 4 x 20 mm
screws, insert and fasten the two screws on
the two pre-drilled holes on the backing plate.
Insert and fasten the screw M 5 x 20 mm in the
hole located in the middle of the backing plate,
as indicated on picture 8 on your left.
Now completely tighten all the backing
fastening screws to avoid them loosening when
working, which would impair the proper
operation of the system.
5.2 - MOUNTING THE ROLL HOLDER UNIT
Place the printer on its side, unpack the roll
holder unit and take off from the tool kit the two
screws M 5 x 16 mm.
Place the roll holder unit on the back part of the
backing plate, so that the external roll holder is
in front of the proper slot created on the rear
panel to let labels to pass.
Insert and fasten the two screws of the roll
holder unit on the two pre-drilled holes on the
backing plate, as indicated on picture 9 on
your left.
Now completely tighten the screws to avoid any movement of the roll holder unit
under the weight of the label rolls.
PICTURE 9 - ROLL HOLDER UNIT
FASTENING.