User manual

AP 230 USER MANUAL 15
5.1 - MOUNTING THE BACKING PLATE
Unpack the printer and place it upside down on a table top.
Remove the two rubber feet, as indicated on
picture 6 on your left, unlocking the two screws
that fasten them at the base of the printer.
Unscrew the M 5 x 20 mm screw located in the
middle of the base of the printer, as indicated
on picture 7 on your left.
Place the backing plate on the printer so that the plate holes will match the printer
holes.
PICTURE 6 - RUBBER FEET
PICTURE 7 - MIDDLE M 5 SCREW.