User manual

AP 230 USER MANUAL 12
4 - STORAGE AND TRANSPORT
In case of non immediate use the AP 230 should be stored with its original package.
The enviromental conditions are the following:
- Temperature: from 5° to 35° C
- Humidity: 20% to 90% non condensing.
4.1 - TRANSPORT
In order to provide a safety moving of the AP 230 follow the under below instructions:
WARNING: Before entering into interdiction zone created all around
the AP 230 system, follow carefully all the indication listed
"SAFETY MODE FOR THE MAINTENANCE" procedure
described at point 1 and 2 of the paragraph 8.1.
a) Transport inside of the factories
- Disconnect the AP 230 applicator system from the power supply (see paragraph
6.1)
- Disconnect the compressed-air supply tube (see paragraph 7)
- Disconnect the data cable from the serial port mounted on the rear panel of the
printer (see paragraph 6.2)
- Disconnect the cable of the object sensing photocell by the proper plug on the
rear panel of the printer (see paragraph 6.2)
- Keep off the applicator from applying line.
b) Transport outside the factory
Disconnect the applicator by the power and data supply, as indicated on point “a”,
dismantling the parts comprising the applicator, following instructions on paragraph
5 point “5.1 - 5.2 - 5-3” and store into the standard original package as indicated on
the picture 4 of page. 10.