Specifications

DATAPROCESS EUROPE S.p.A.
ST3xx ST4xx ST5xx
– PROGRAMMING MANUAL -
Pag.38
/E00300060/F211/I5000105H:I:S
/A223
/E00300080/I605HIDMY00010070000000000000Û
/E00300170/I603HIS000110400000000Û
/E00300250/I607*H.I.S*00013040*HH.MM.SS*Û
/E00300310/I607o d O Y0001B040***************Û
/E00300370/I607o d O Y0001b040***************Û
/E02700080/I603HIS00014070000000Û
/E02700170/I603HIS00015040000000Û
/E03300250/I603HIS00019040000000Û
/R1 /E05200080/I603HIS00024070000000Û
/R0 /E00300444/I1300000101
/W0004
17.28 /Jhhss
The
/J
command is used to set the shape ratio. The most suitable value to obtain a scale
of 1:1 in the X and Y axes is memorised in the default configuration of every printer. This
parameter can be changed for special applications where it is necessary to change the
printing roller or the paper feed settings.
It must be followed by 2 parameters, each of two digits with the following significance:
hh
printhead cycle / period (values: from 01 to 99);
ss
motor feed passes / period (values: from 01 to 99);
The speed of the paper is inversely proportional to the parameter
ss.
The shape ratio is
determined by the ratio between
hh
and
ss
. If the value of these two parameters is correct,
the printing of a square should give exactly the same length sides.
17.29 /Kpdet
The
/K
command is used to define the operation mode of the printer.
It must be followed by 4 single parameters having the following significance:
p
continuous paper / die-cut labels / black mark (values : from 0 to 3).
ST3xx ST4xx ST5xx
0 Continuous paper Continuous paper
1 Die cut labels Lateral transparency photo
2 not supported Central transparency photo
3 Black mark Reflective photo
d
label dispenser photo / applicator (values: 0,1,3,4);
ST3xx ST4xx ST5xx
Synchronism Polarity
0 No dispenser Applicator Low active
1 Yes dispenser Print Low active
4 Applicator High active
5 Print High active