Specifications

DATAPROCESS EUROPE S.p.A.
ST3xx ST4xx ST5xx
– PROGRAMMING MANUAL -
Pag.34
N Courier Bold 8 pts 37
O Courier Bold 9 pts 43
P Courier Bold 12 pts 56
Q Courier Bold 16 pts 76
R Courier Bold 20 pts 92
S Courier Bold 24 pts 104
T Courier Bold 32 pts 150
Note: the expansion factors are assigned to the character independently of the
orientation. There is a limit on the expansion determined by the paper width. The
values from 1 to 8 are recognised correctly whereas 9 is treated as an 8.
17.25 /Gxxxxyyyy
The
/G
is used to position the origin of the coordinates.
It must be followed by two parameters each of 4 digits with the following significance:
xxxx
horizontal position in dots (values: from 0000 to Width);
yyyy
vertical position in dots (values: from 0000 to Length).
The maximum values of Width and Length depend on the dimensions of the bitmap (fixed
by the 3rd and 4th parameters of the
/ $>T
command) and the orientation of the label
(fixed by the command
/ *O
).
Note: when this command is executed, the position of the cursor will be the
new origin and the subsequent use of the /E command will refer to that origin.
17.26 /Hnnnn
The
/H
command is used to control the alignment of the label under the printhead, if the
label sensor is active, otherwise it will control the spacing between prints when continu-
ous paper is used. A value in H which is different to 0 in version 2.0 onwards will deacti-
vate the auto positioning of the label.
With H0000 and the autocalibratione, the label will come set automatically in the point
more correct to maximize the area of print. If you wants correct this location you may act
on the first 4 digit of the /G command.