Specifications

DATAPROCESS EUROPE S.p.A.
ST3xx ST4xx ST5xx
– PROGRAMMING MANUAL -
Pag.23
b
speed, 1 digit (0=38400, 1=19200, 2=9600, 3=4800, 4=2400, 5=1200, 6=600, 7=300
baud);
d
Number of data bits, 1 digit (allowed: 7 or 8);
p
parity, 1 character (N=no, Z=zero, O=odd, E=even);
s
Stop bit , 1 digit (1 or 2).
It is not necessary to memorise the command.
Note: when the serial parameters are changed with this command it is neces-
sary (in any old versions of firmware) to switch the printer off and then on again to
implement the changes.
17.9 /$>Ch
The
/$>C
is used to change the character "/" used as the identifier for the start of a pro-
gramming command for another character.
It must be followed by a single character which represents the new header for the com-
mands (allowed values: any ASCII or extended ASCII code from 0 to 255).
For uniformity with the ST230 printer, the “/” character is factory set as default header and
this manual is based on this character.
Note: when the command header is changed with this command it is necessary
to switch the printer off and then on again to make the change effective.
17.10 /$>Ln00
The
/$>Ln00
is used to select the language for the date format.
It must always be followed by the following parameters:
n
0 = Italia, 1 = English , 2= Franch
00=not used, always set to 00
17.11 /$>Ohhmmssggmmaaaa
The
/$>O
command is used to change the time and date.
The command must always be followed by 6 parameters in the following order:
hh
hour
(values:00 a 23)
mm
minutes
(values :00 to 59)
ss
seconds
(values:00 to 59)
gg
day
(values: 01 to 31)
mm
month
(values: 01 to 12)
aaaa
year