Specifications

Page 18 iBootBar V1.5x
Device Commands
Command
Description
Admin
Fact Default
getdevices/getall/getoutlets
This command displays a list of connected devices, and their current status. No
getdevice<#1‐#16/devname>
Get device information. Displays the device name, and all outlet names and current
status
Yes Dataprobe
setdevice<#1‐#16>name<name>
Set the name of the selected iBootBar. 20 characters max.
getcurrent
Gets the measured current of the local iBootBar Yes
getdevice<#1‐#16/devname>current
Get the measured current of the selected iBootBar
getcycle
Get or set the cycle time in seconds. No 10
setcycle<1‐99>
getdelay
Get or set the delay time in seconds. No 1
setdelay<1‐99>
getcurrentalarm
High and Low alarms are used to monitor current conditions and send an alert by
email, SNMP and syslog when the high or low thresholds are exceeded.
From 0.0 to 10.0/15.0/20.0 (depending on max current for device) in 0.1 amp
increments. For devices with two Mains, Main A and Main B are set separately, but
displayed together with the get command.
Yes Highalarm:
10.0 for 10 Amp
Models
15.0 for 15 Amp
Models
20.0 for 20 Amp
Models
Lowalarm:
0.0 Amp
getdevice<#1‐#16/devname>currentalarm
setmain<a/b>highalarm<nn.n>
setdevice<#1‐#16/devname>main<a/b>
highalarm<nn.n>
setmain<a/b>highalarm<nn.n>
setdevice<#1‐#16/devname>main<a/b>
lowalarm<nn.n>