Specifications

V140602E iBoot-DC Page 12
6.5. Event Scheduling
iBoot-DC can schedule up to eight
reoccurring power events. Set the
starting date and time, plus the action
to be taken and any repeat cycle for
each.
To enable the time scheduling
function:
Enter an accessible Network Time
Server and check the Enable box. A
list of public time servers is available
at http://www.ntp.org/ Set your local
time zone relative to GMT.
Once the time server is active,
scheduled events can occur. Up to eight independent scheduled events can be programmed.
Date: Set the initial date for the event. The format for the date is mm/dd/yyyy.
Time: Set the initial time for the event. The format for the time is hh:mm with hours in 24 hour format.
Repeat: Set the repeat multiplier, if desired. Set the number from 0 to 999 and either Days, Hours, or
Minutes. To have the schedule repeat every two days, set this number to 2.
Action: Set the event Action; On, Off or Cycle.
Hold/Run: Click Hold to pause the scheduled event. Click Run to re-start the scheduled event.
Delete: Delete the scheduled event.
Click Save to save the current settings. Click Reset to delete any unwanted changes.
6.6. Password Settings
The iBoot-DC supports three modes of user and
password operation.
Login Required: This mode supports both User
and Admin users. Each user has a settable
password.
Auto Login: This mode does not require a
username of password for the User level operation.
No login challenge will be required for any mode of
operation, until any setup function is requested.
The Admin username and password is required for
any admin functions.
User Disabled: There is no User account. The Admin username and password will be required for
operation and setup functions across all modes of operation. This is the factory default mode.