Specifications

Page 9
8. Now your terminal is configured to start a Standard connection after you register on the
network.
9. Click on Setting on the left Menu.
10. Select the NO radio button for Pointing required at power up.
11. Select the YES radio button for the terminal will switch on when external power is connected.
12. Click APPLY before leaving the page.
13. Click on LAN from the menu on the Left.
14. Click on Port Forwarding select ENABLE.
15. Check the Active box and enter 80 for the Incoming port Range and the IP address you
configured in your iBoot-G2 ex. 192.168.0.X then for the destination port 80
16. Your configuration should look like this:
17. Click APPLY before leaving the page.
18. Restart your terminal, after properly pointing the terminal. The Explorer terminal will register
automatically on the BGAN network you will be connected automatically with a Standard
connection.
7.2 Setting up BGAN – Wideye™ Sabre™ I
The terminal needs to be configured to switch on when external power is connected; no Pointing is
required at power up and to automatically activate a data connection. The BGAN terminal and can
be configured from the Wideye™ Sabre I’s built-in web server (via a PC’s web browser).
2. Open your internet web browser and type the following IP address in the address bar:
192.168.1.35
3.
Then you will prompt for the User Name: Admin Password: wideye. Now you should see
the screen below.