User manual

INTERFACE CONNECTIONS
Appendix D
D-1
Copyright (C) Dataplex Pty Ltd
INTERFACE CONNECTIONS
The following Section applies to the DPX-213 only. There are two cables required for use
with the DPX-213, one cable for the phone line and another cable that is connected
between the modem and the terminal. The wiring for these cables is described in this
Section.
Line and Phone Connector
The phone and line connector are both RJ-11 type connectors. The Line Connector has
mode 3 connections in addition to the standard tip and ring connections. See the Figure
below for details.
VIEW LOOKING AT
DPX-213 REAR PANEL
PIN
11
2
3
4
5
6
LINE
Leased Line
Not Used
Tip
Ring
Not Used
Leased Line
Figure D.1 RJ-11 Connector Wiring