User manual

II
Document No 113-213-
01 Rev 1.0
WARNING
When operating the DPX213 from a DC supply ensure that any devices that are
connected to the DPX213 have a common NEGATIVE ground or are powered
from an isolated source. It is recommended that the supply be connected via a
disconnection device or an over-current protection device.
SAFETY
The 48V free standing unit is fitted with a 2m power supply cable with bare wire
ends. This power supply cable must be connected to the power source via a
disconnection device or an over-current protection device. A circuit breaker rated
1A, 100 VDC will satisfy both requirements. Observe correct polarity:
• Red wire to positive;
• Black wire to negative.
COPYRIGHT
This manual is copyrighted © 1994 by Dataplex Pty. Ltd. with all rights reserved.
This manual cannot be reproduced in any form without the prior written consent
of Dataplex Pty. Ltd. No patent liability is assumed with respect to the use of the
information contained in this manual.
TRADEMARKS
DPX-213 is a trademark of Dataplex Pty. Ltd.
DATAPLEX is a trademark of Dataplex Pty. Ltd.