Specifications

HYDROLOGICAL SERVICES
DL3 100-09 IMP
Issue 2: 15/11/2005
Red Connector Pin C
Carrier Detect (CD)
Red Connector Pin A
Tx Data
RRDL-3 Logger
Red Connector Pin E
G
nd
DB25
2
8
7
R
xD
CD
Gnd
Red Connector Pin B
Rx Data
3
T
xD
Hayes Compatible
Modem
Consult Modem
manual to confirm
p
inout
Communicati on
Channel
Connection to a PC through a modem (Handshake = Xon/Xoff)
3.1.4 DIP Switches
To obtain access to the DIP switches, first remove the cover of the RRDL-3 logger, then carefully
remove the battery pack, being careful not to damage the foam seal that isolates the batteries from
the electronics. The DIP switch should be visible with the individual switch numbers being printed
on the switch itself as well as the text "OFF" on one side of the switch.
Baud Rate Dip Sw 1-1 Dip Sw 1-2
300 Off Off
1200 On Off
9600 On On
DIP Switch Off On
Sw 1-3 No Handshake Handshake Enabled
Sw 1-4 Xon / Xoff Handshake Hardware Handshake
Sw 1-5 Go to sleep in 1 minute Go to sleep in 5 minutes
Sw 1-6 River is Quadrature River is 4-20mA
Sw1-7 8bits/Noparity/1stopbit 7bits/EvenParity/1stopbit
Sw 1-8 Not Used Not Used
Notes :
Sw 1-4 is only active if handshake is enabled by Sw1-3.
Xon/Xoff handshake is recommended.
Sw 1-6 is only active if the software switch MO is set to off (Rain + River mode).
Switches are read continuously and therefore may be changed while the logger is powered