Product guide

M-Class

Mark II

Important Safety Instructions

This printer has been carefully designed to provide many years of safe, reliable performance. As with all types of electrical equipment,

however, there are a few basic precautions you should take to avoid hurting yourself or damaging equipment.

• Carefully read the provided installation and operating instructions.

• Read and follow all warning instruction labels on the printer.

• Place the printer on a at, rm, solid surface.

• Make sure all openings on the printer remain unblocked; never insert anything into the openings or ventilation slots.

• Do not place the printer near a heat source.

• Do not use your printer near water, or spill liquid into it.

• Be certain that your power source matches a listed voltage rating for the printer (if unsure, check with your dealer or local utility

company).

• Do not place the power cord where it can be stepped on; and, if the power cord becomes damaged, immediately replace it.

• If service is required, use only qualied trained technicians to repair your printer.

UL60950-1: 2003 1st Edition Information Technology Equipment

CSA C22.2 No. 60950-1-03 1st Edition; April 2003

EN60950

For 230 Volt Operation (Europe): Use a cord set, marked “HAR,” consisting of a min H05VV-F cord which has

a minimum 0.75 square mm diameter conductors, provided with an IEC 320 receptacle and a male plug for the

country of installation rated 6A, 250V

Für 230 Volt (Europa): Benützen Sie ein Kabel, das mit “HAR” markiert ist, bestehend mindestens aus einem

H05VV-F Kabel, das mindestens 0,75 Quadratmillimeter Drahtdurchmesser hat; sowie eine IEC320 Steckdose

und einen für das Land geeigneten Stecker, 6A, 250 Volt.

As an Energy Star Partner, the manufacturer has determined that this product meets the Energy Star guidelines

for energy efﬁciency.

The manufacturer declares under sole responsibility that this product conforms to the following standards or